Hey everyone, I need some help with my 2018 Polaris Ranger XP 1000. The engine cranks over but it just won’t start. I’ve tried a few things but can’t seem to figure it out. Here are some details: The battery is fully charged ...Read more
Repair Forum Latest Questions
Hey everyone, I own a 2007 Polaris Scrambler 500, and I’ve recently run into an issue where the idle speed seems to be way too high. When I start the engine, it revs much higher than normal, and it doesn’t settle ...Read more
Hey everyone, I’m having some trouble with my 2007 Polaris Scrambler 500. For some reason, the engine just won’t turn on. When I press the start button, the crankshaft doesn’t turn at all. It’s like it’s completely dead. I’ve checked the ...Read more
I’m having trouble with my 2004 Suzuki 200hp outboard motor. It just won’t start, and I’m stumped on what might be causing the issue. The battery is fully charged, and I’ve ensured that all cables and wires are securely ...Read more
I’m having trouble with my 2011 Mercury 40hp EFI outboard motor. It cranks and starts up just fine, but then it stalls out after a few seconds. I’m unsure what might be causing this issue. I’ve checked the basics, like ...Read more
Hey folks, I’ve got a 2007 Polaris Scrambler 500 that’s been backfiring quite a bit, especially when I let off the throttle. Any ideas what could be causing this?
I’m having trouble with my 2004 Yamaha Rhino 660. It’s been difficult to start lately, whether it’s cold, warm, or has been sitting for a few days. The engine takes several attempts to crank before it finally starts up. I’ve ...Read more
I’m having some trouble with my 2012 Evinrude 90hp E-TEC outboard motor. It cranks multiple times before it finally fires up, and I’m not sure what might be causing this issue. The battery is fully charged, so I know ...Read more
I’m having some trouble with my 2005 Polaris Sportsman 800 EFI. The engine cranks just fine, but it won’t start up. It seems like it’s not firing, even though it’s turning over. I’ve checked the basics but I’m stumped on ...Read more